The structure principle of vertical series offset press is to change the arrangement angle of three rollers, so that the printing pressure is better and printing dot is clearer. It increases the space of paper receiving and stamping parts, and it is more convenient to clean and maintain the press drum.

product mix

1. Imported bearings and electrical components are used.

2. The copper sleeve is made of tin bronze.

3. The wearing link is treated by nitriding surface.

4. The wall plate and drum are thickened to improve the service life of the whole machine.

5. Safety switch is installed in dangerous parts

6. Double sheet detection, double rotation function, skew detection, paper jam detection.

7. Automatic lowering device of the paper receiving table, lower limit sensor of the paper receiving table, powder spraying device and electrostatic device.

Features of pneumatic control function

1. Compared with the traditional electromagnet pull rod structure, the plate cylinder, the imprint cylinder and the rubber cylinder adopt pneumatic pressure, which solves the problem of easy damage in the pull rod mode. And the pressure is stable, the dot is clear, and the reducibility is good.

2. Compared with the traditional electromagnet pull rod type, the pneumatic mode is adopted in the code pulling, especially in the printing of non carbon copy paper, which has fast response and is not easy to make mistakes.